Details:
- Driveshaft Diameter: 3.5 Inch
- Driveshaft Material: Aluminum
- Driveshaft Style: One Piece Design
- Transmission Type: Manual
- Balanced: Yes
- Horsepower Rating: 1,200 hp
Features:
- Direct Bolt-On
- One Piece Design
- Billet Aluminum Construction
- 12.9 Strength Hardware
- 300m Stub System
- Made in the USA
DSS has done extensive testing with stock rears and with their 9" kit and believe this to the the most cost effective trouble free drive shaft for the Camaro available today. The shaft will come with DSS' signature billet plates for each end so you done have to go in to the rear taking a chance on upsetting the crush collar. The shaft comes with a 300m stub system mounted into a billet aluminum plate to ensure not only strength but lighter weight than the normal way of doing this type of end (look closely at the CV end - its not all steel). The shaft only weighs 22lbs and come with special 12.9 uber strength hardware with back up lock nuts to ensure no loose bolts. Driveshaft Shop's been using this Billet aluminum style plate for over 10 years on thousands of 1000+Hp vehicles without any bolt issues.
Note: Rear Subframe/Cradle Lock-Out kit MUST BE installed on the vehicle prior to installing a Driveshaft Shop 1-Piece Driveshaft. Any damage to the driveshaft, or any subsequent damage caused by failing to properly reinforce the rear cradle and limit movement will void any and all warranty provided by The Driveshaft Shop.
Part Number: 610209
